Mettler Toledo M400 Especificações descarregar pdf (Página 14)

Transmitter Multiparameter M400 14

Printed in Switzerland 52 121 378

4.1.2 Installation procedure

For Wall Mount:

– Remove rear cover from front housing.

– Start by unscrewing the four screws located on the face of the transmitter, in each corner.

This allows the front cover to swing away from the rear housing.

– Remove the hinge-pin by squeezing the pin from each end.

This allows the front housing to be removed from the rear housing

– Drill out wall-mount breakthroughs in the rear housing.

– Mount rear housing to wall using appropriate mounting hardware for wall surface. Be sure

it is level and securely fastened and the installation adheres to any and all clearance

dimensions required for transmitter service and maintenance.

– Insert two black protective covers (supplied with the M400 transmitter) over the ﬁxing

hardware and into the space on the inside back cover, as shown in the drawing below.

This is necessary to maintain unit integrity.

– Replace the front housing to the rear housing. The unit is ready to be wired.

For Pipe Mount:

– Use only manufacturer-supplied components for pipe-mounting the M400 transmitter and

install per the supplied instructions. See section 15 for ordering information.

4.1.3 1/2DIN version – Assembly

1 3 Pg 13.5 cable glands

2 2 plastic plugs

3 4 screws

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Sem comentários

Mettler Toledo M400 Especificações Página 14